Garage Door Garage Door Safety Inspections Kuna, ID
Garage door safety inspections in Kuna, ID is routine work for us. Local failure modes — loosened hardware from constant expansion and contraction, heat-warped panels on west-facing steel doors, dried, cracked bottom seals that let dust into the garage, and faded, sun-baked panel finishes on exposed doors — are exactly what our trucks are stocked for.
Ask any Kuna tech and they'll tell you the climate decides what fails. Dry conditions year-round with big seasonal swings — scorching summers, cold winters, and frequent wind-driven dust brings fine wind-borne dust that grinds down track rollers, intense UV that embrittles rubber gaskets and bottom seals, and extreme summer heat that bakes and warps lightweight steel panels, year after year.
Kuna homeowners usually call us about one of a few things: loosened hardware from constant expansion and contraction, heat-warped panels on west-facing steel doors, dried, cracked bottom seals that let dust into the garage, and faded, sun-baked panel finishes on exposed doors. We diagnose the real cause — not just the symptom — before quoting a flat rate.
Safety inspections are formal, documented evaluations of the entire garage door system — useful for home sales (preempt buyer-inspection negotiations), insurance audits (some carriers require periodic verification), post-incident review (after a near-miss or actual injury), and rental-property compliance. The inspection covers every safety-critical component plus structural items, and produces a signed PDF report that meets the documentation needs of most buyers, insurers, and property managers.
Our standard report covers: UL-325 compliance (photo-eyes present, aligned, and triggering auto-reverse on obstruction test), spring health (visible wear, age, cycle estimate), cable health (fray, corrosion, secure termination), drum and shaft integrity (set-screws tight, drums spooled correctly), opener motor and gear health (audible inspection, force/travel calibration), photo-eye function, manual-release operation, balance verification, and structural items (track alignment, bracket fasteners, panel integrity, hinge condition). Every check is photographed and the report includes the photographs.
Inspections take 60–90 minutes. The signed PDF is emailed within 4 hours of completion. If we find issues, we present a separate flat-rate quote for any repairs — you can address them during the same visit, schedule a return, or share the report with the relevant party (buyer, insurer, etc.) and decide later.